In this video i Ankur choudhary describe and provide information about SPC flooring installation SPC FLOOR INSTALLATION PROCESS IS FOLLOWING
Start in a corner by placing the first plank with
the tongue side facing the wall. Use spacers
along each wall to maintain an expansion
space of 5/16 in-3/8 in between the wall and
the flooring.
To attach the second plank, insert the end
tongue into the end groove of the very first
plank at an angle of approx. 15-20 degrees.
When lowered, the plank will click into place.
Line up edges carefully. The planks should be
flat to the floor.
Continue connecting the first row until you
reach the last full plank. Fit the last plank by
rotating the plank 180 with the pattern site
upward, place beside row. Measure and mark,
then using a ruler and utility knife, score the
plank and snap off. Attach as described above.
Begin the next row with the off cut piece from
the previous row to stagger the pattern. Please
should be a minimum of 8 in long and joint
offset should be at least 16 in
NOTE:It is faster to assemble planks into a new
row at the ends and then attach the entire row
to the previous row on the long sides
To start your second row,lay your first plank on
the subfloor. Take your second plank, Insert the
end tongue into the end groove of the first plank
at an angle of approx. 15-20 degrees. When
labeled, the plank will click into place with light
pressure. The planks should be first to the floor.
Make sure gaps are as small as possible. Con
tinue assembling the planks this way until you
have your second row complete.
To attach the second row to the first row, tit
and push the side tongue into the side groove
of the first panel at an angle of approx. 15-20
degrees. Lower and click into place lining the
edges up carefully Continue laying remaining
planks in this manner.
To fit the last row, lay a plank on top of the
previous row. With the tongue to the wall lay
another plank upside down on the one to be
measured and use it as a ruler Don't forget to
allow room for spacers. Cut the plank and al
tach into position.
Door frames and heating veritas also require
expansion room, First cut the plank to the cor
rect length. Then place the cut plank next to its
actual position and use a ruler to measure the
areas to be cut out and mark them. Cut out the
marked points allowing the necessary expan
sion distance on each side.
You can trim door frames by tuning a plank
upside down and using a handsaw to cut away
the necessary height so that planks slide easily
under the frames
Note:
If the total length of installation area is over 33
ft.it must be left an expansion space of 5/16 in
3/8 in and so on.
If the total width of installation area is over 26
ft.t must be left an expansion space of 5/16 in
3/8 in and so on
if not,we'll not responsible for any damages or
claims after installation
you can also get an idea from my wooden floor installation video
thanks for watching spc floor video
like share and subscribe
0 Comments